Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Instrukcja Użytkownika Pobierz pdf (Strona 20)

Part No. 4801-5169 Rev 12-07 Rollup Curtain System Page 20

10. End Pocket installation

The End Pockets are 12' in length and must be cut to the length of the total system.

1. Cut End Pockets to the desired length.

1. Fasten C-channel to brackets with sheet metal screws to form C-channel assembly. Repeat for top C-channel,

middle C-channel, and bottom C-channel assemblies. NOTE: Be sure to use End Pocket Spreader Bracket.

2. Attach the top and bottom Spreader Bars with sheet metal screws.

3. Attach End Pocket with sheet metal screws through the flange on the end of the End Pocket.

4. Attach the front of the Spreader bars with sheet metal screws.

11. Insert Vent Bolt

Locate the Vent Bolt in the Vinyl seal under the motor

cover plate. See Figure 16. Remove the bolt in the top

of the gear box and insert the Vent Screw. See Figure

12.

Sheet Metal

Screws

End Pocket

Optional

C-Channel fo

High Wind Use

Spreader bar

(Attach back with

sheet metal screws

)

Spreader bar (Attach

back with sheet metal

screws)

Figure 11

Figure 12 – Insert Vent Bolt

Remove bolt for Vent

Bolt

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Brak uwag

Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Instrukcja Użytkownika Strona 20