Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Instrukcja Użytkownika Pobierz pdf (Strona 18)

Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 18

Table 2

Distance Of Motor Mount Bracket From End Of Curtain

System

(Opening Size)

System

(Opening Size)

4' 75 in. (190.5 cm) 6' 99 in. (251.5 cm)

5' 87 in. (221.0 cm) 7' 111 in. (281.9 cm)

8. Pivot Gearbox Drive

IMPORTANT!

Two Systems On A Common Wall Must Meet At A Vertical Column!

If Adjacent Systems Are Installed Along A Sidewall, Space Motor Mount Brackets Equally

On Each Side Of A Vertical Column. Distance Of Separation Between Motor Mount

Brackets Should Be 3 ft. 3-1/2 in. (100 cm) Center-To-Center.

1. Close curtain to fully lowered position.

2. Position top edge of motor mount bracket even with top of curtain. Position center of motor

mount bracket at a distance D from end of curtain as shown in Fig. 8. Refer to Table 2 below to

determine distance D for system you are installing. NOTE: If two adjacent systems are installed,

equally space motor mounts on each side of a vertical column. Locate motor mounts 3 ft. 3-1/2

in. (100 cm) apart center-to-center. See Fig. 8 & Fig. 9 below.

3. Hold motor mount bracket against panel at position where bracket is to be attached (from step 2

above). Mark the four screw holes of motor mount bracket. Or use hole pattern as shown to

mark screw hole locations. Drill holes for 3/8-16 screws. See Fig. 9.

4. Firmly fasten motor mount bracket to stringer using 3/8-16 screws and nuts as shown in Fig. 9.

5. Attach motor support arm to motor using M8 screws provided. See Fig. 10.

D ± 3"

3' 3-1/2"

FIG. 8

Placement Of

Motor Mount Brackets

Motor Mount Bracket

ertical column is

located behind panel.

See Fig. 9.

100 cm

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Brak uwag

Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Instrukcja Użytkownika Strona 18