Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Instrukcja Użytkownika Strona 28

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 38
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 27
Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 28
13. Drive Pocket
NOTE: C-channel should be cut to length of pocket.
1. Detail A. Fasten C-channel to brackets with sheet metal screws to form C-channel assembly. Repeat for
top C-channel, middle C-channel, and bottom C-channel assemblies. Be sure to use correct bracket. See
NOTE in Fig. 20 below.
2. Detail B. Position top C-channel assembly as shown. Attach C-channel assembly to top stringer with
sheet metal screws.
3. Detail C. Position middle C-channel assembly as shown. Attach C-channel assembly to middle stringer
with sheet metal screws.
4. Detail D. Position bottom C-channel assembly as shown. Attach bottom C-channel assembly to concrete
foundation with Tapcon screws.
5. Detail E. Attach panels to C-channels with sheet metal screws.
6. Detail E. Attach cap to each end of system as shown.
DETAIL A
DETAIL B
DETAIL C
DETAIL D
8" C-Channel
(not supplied)
Sheet
Metal
screw
8" C-channel
(not supplied)
4.0"
(10.2 cm)
4.0"
(10.2 cm)
8" C-channel
(not supplied)
4.0"
(10.2 cm)
Tapcon screw
Concrete
End cap
End cap
DETAIL E
TOP VIEW
Metal panel
Sheet metal
screw
FIG. 20
Drive Pocket
Bracket
Sheet metal
screw
NOTE:
C-channel
Should Be Cut
To Length Of
Pocket. 6 Ft. is
Recommended.
NOTE: Drive Pocket Bracket
Extends Outward Farther
Than End Pocket Bracket!
Make sure to use correct
bracket.
NOTE: Drive pocket bracket
extends 6" (15.2 cm).
18.5" (47 cm) 2"
(
5.1 cm
)
NOTE: Pocket extends
over universal
.
Drive pipe
Przeglądanie stron 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Komentarze do niniejszej Instrukcji

Brak uwag